Wave Winding and Universal Winding Transformer Manufacturers in India

Universal pi wound winding custom design choke inductor coil or transformers

In carrier frequency transmitters, transformers are normally used for coupling between stages and for coupling the output stage to the line. They sometimes transform a large amount of carrier power. Coils are usually wound in single layers, spaced well apart to reduce capacitance, and have but few turns. If the necessary turns cannot be wound in a single layer, a bank winding like that shown in below Fig. may be used.

Two-layer bank winding
Two-layer bank winding.

This winding has more capacitance than a single layer but much less than two layers wound in the ordinary way. Since intrawinding layer-to-layer capacitance is zero in these transformers, the resonance frequency fr is usually determined by winding-to-winding capacitance.

In high impedance circuits, the winding-to-winding capacitance may be reduced by winding “pies” or self-supporting vertical sections side by side. Pies are wound with one or more throws per turn and may be several turns wide. They have the general appearance of below Fig.

Pie-section windings.
Pie-section windings.

High, narrow core windows or several pies are desirable to reduce leakage inductance. Transformer loss is mostly core loss. Two-mil grain-oriented steel can be used advantageously in such transformers, because of its low losses and high permeability. In transmitter operation, class AB or class B amplifiers are commonly used, with or without modulation, which may be as high as 100 per cent. In a receiver, input and interstage transformers also are employed, mainly to obtain voltage gain or for isolation purposes. Similar transformers are used for line matching, especially where overhead lines are connected to underground cables. Line impedance changes abruptly, and transformers may be necessary for good power transfer.

Universal Winding Transformers

Also highly advantageous for high voltage applications, universal winding transformers feature a design with an increased coil build. This provides more space between the turns, allowing freer penetration of dielectric oil onto the coil. More oil not only creates additional isolation, but also creates much reduced chances of arcing and corona.